Gold Supporter
- Messages
- 186
- Reactions
- 263
You buy Omen parts and make one from old scraps lol. Certainly above my gun budget and my old CNCs need some exercise.
Already have a KAK magnum bolt & a BCA sidecharge AR10 BC. Some how google said I needed an Omen 14 magazine and an Omen firing pin.
So $160 later I'm off and running.
I had this want to reflow 6061 in my old heat-treat furnace so I did...about 6 times. Eventually I had to raise the mold to get the required amount of alum, open top molds shrink like crazy in the middle. Stack old bar rems in heat to 1250 degrees, stir and cool fast then pull bottom of the mold off and remove with press. Heatreat at 450 for 6 hours. I'm only doing the lower this way, the upper will be proper bar stock.
Got a new Qidi Xmax3 so it's been hard at work printing mech fit prototypes ...
Already have a KAK magnum bolt & a BCA sidecharge AR10 BC. Some how google said I needed an Omen 14 magazine and an Omen firing pin.
So $160 later I'm off and running.
I had this want to reflow 6061 in my old heat-treat furnace so I did...about 6 times. Eventually I had to raise the mold to get the required amount of alum, open top molds shrink like crazy in the middle. Stack old bar rems in heat to 1250 degrees, stir and cool fast then pull bottom of the mold off and remove with press. Heatreat at 450 for 6 hours. I'm only doing the lower this way, the upper will be proper bar stock.
Got a new Qidi Xmax3 so it's been hard at work printing mech fit prototypes ...