- Messages
- 101
- Reactions
- 98
The punch you pictured was not a starter, maybe you used something different, I don't know...That wasn't the problem. I had no problem "starting" the roll pin. Hence why the roll pin is in as far as needed to be to hold the forward assist in place. The roll pin was protruding and wouldn't fully sit flush. A pin that's stuck can't be made to sit flush with the starter. And yes I tried.
Misalignment is probably the number one cause of problems I've seen over the years and building hundreds of guns. The pin being misaligned can begin to shear material off the wall and also as it is further driven in won't line up with the other side of the hole on the inside. Makes me think that's why you couldn't push it in any further.
That pin tends to be more problematic than all the others.
I use two punches and a little oil for that pin installation, the starter then a drift, or aka: Roll pin punch or pin punch.