- Messages
- 50
- Reactions
- 71
I've been searching forums for a solution to capping the hole on my Magpul Vertical Foregrip. I have seen several people pose the question of how to cap that grip, one of the solutions was to use the cap from a different brand VFG, however this cap is not sold separately. Another solution I saw proposed was to use a cork. That's what I did. I got this black rubber cork from Ace Hardware for around $2 in their bulk hardware section. I used a razor blade to shave two angled flat sides, cutting a small amount at a time until it fit really tight. It's not completely waterproof, but very close to it. I put a couple batteries inside the grip, I put each battery in a tiny plastic ziplock in case any moisture does happen to get inside. I'm considering drilling a hole through both sides of the grip and the cork in order to install a locking pin, but that might not be necessary. Just wanted to share this solution I came up with for a common problem. I would love to hear your ideas and any other solutions you have come across!